Motec C185 Bedienungsanleitung PDF herunterladen (Seite 27)

22 Configuration MoTeC

Connections

Configuring Inputs

• On the Connections menu, click Devices

• Select the device (e.g. C185) and then click the Input pins tab

This will list all inputs available for this product

Note: Some inputs require the 52 I/O Upgrade to make them available.

See C185 Upgrades

• Select the input and click Channel (or double click the input)

• Assign a measurement channel to the input and click OK

The channel needs to be calibrated using one of two options

• Select Load Cal if a pre-defined calibration is available

• Double-click the input to enter a calibration

Other tasks:

• Change Cal – to change the calibration

• Spd Levels – only for speed inputs

• Settings – to set default

Configuring Outputs

• On the Connections menu, click Devices

• Select device (e.g. C185) and then click the Output Pins tab to list all

outputs available for this product

Note: Some outputs require 52 I/O Upgrade to make them available. See

C185 Upgrades.

• Select the output and click Change (or doubleclick the output)

• Select a mode to make appropriate settings available

• Follow the directions on the screen and when all settings are done click

Configuring Communications

• On the Connections menu, click Communications

• Select an available communications section (CAN or RS232)

• Click Select and choose one of the available communications templates

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 84 85

Keine Kommentare

Motec C185 Bedienungsanleitung Seite 27