Motec C185 Bedienungsanleitung PDF herunterladen (Seite 13)

8 Installation MoTeC

Installation

Mounting and Wiring

C185 has three threaded mounting posts. For further detail see Mounting

Dimensions.

Mounting Tips

• Avoid twisting the case: use washers between the unit and the mounting

panel to ensure that the unit is mounted only at the mounting points and

do not over tighten the mounting screws.

• Vibration isolation may be desirable if the vehicle vibrates severely.

• Mount so that the connector may be easily accessed.

• Orientation: for best contrast, the display should be viewed at an angle of

approximately 20 degrees, However the C185 will give good contrast

between 0 and 40 degrees. Display reflections should also be considered

when determining the mounting angle.

20°

The C185 uses a 79 pin Autosport connector. See Connector and Pin List by

Pin Number for full details.

Wiring Tips

• To ensure that the connector is sealed, plug unused holes with filler plugs.

A heat shrink boot may also be used if desired.

• Use 22# Tefzel wire (Mil Spec M22759/16-22) (5 A max at 100 °C)

• Tefzel wire is difficult to strip unless the correct stripping tool is used.

• Be careful not to nick the wires as this may result in wire failure or poor

crimping.

• Some sensor connectors may not be available with 22# terminals, in which

case doubling the wire over gives the equivalent of an 18# wire. This is

suitable for many of the common sensor terminals.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 84 85

Keine Kommentare

Motec C185 Bedienungsanleitung Seite 13